Our friends at Deep Excavation posted about an interesting micropile case study in Northern Baltimore County for a bridge replacement project. The project consisted of 38 Micro Piles; 7†OD X 38 ft. deep including a 7 ft. rock socket, installed on a 3/1 batter, load tested to 272,000 lbs. What caught my attention is the down the hole hammer system used for installing the micropiles. The system uses a ring bit to install the casing and allow the drill string to continue beneath the bedrock elevation to construct the rock sockets. [Source: Read more about this micropile project and see additional photos at Deep Excavation. Image: Deep Excavation]
Related Articles
Crux acquired by Quanta Services
Specialty geotechnical drilling contractor, Crux Subsurface, Inc. of Spokane, Washington was acquired Quanta Services (NYSE: PWR), an S&P 500 company and a leader in infrastructure services for the electric power, pipeline and telecommunications industries according […]
Innovative Foundation System for London Office Building
This has to be one of the most complex geotechnical engineering problems I’ve heard of for a building, if not for any kind of project. For starters, beneath the proposed 10-story office building referred to as Cannon Place lies the Cannon Street Train Station built in 1868. Also beneath the site are walls and foundations of a Roman Governor’s palace. In order to accommodate these features, the building has 21-m cantilevers at each end, with the load bearing happening over two groupings of columns at the 1/3 points. In section it looks quite like a 3-span bridge…without the abutments and stacked 10-stories tall! More after the break. (Images by New Civil Engineer) […]
Thomas J. Tuozzolo, P.E. joins the Board of ADSC
[Editor] Moretrench [/Editor] Vice President Thomas J. Tuozzolo was elected to the Board of the International Association of Foundation Drilling (ASDC) at the IFCEE Conference held in March, 2009. Mr. Tuozzolo, who has overall responsibility […]